Wood floor installation might present a big challenge for a novice builder. Following the best technique for hardwood flooring will make a beautiful, bright, and durable product for on your construction project.

Wood floor installation

1. HARDWOOD FLOORING INSTALLATION AREAS

A wood floor can be installed on grade or above grade in the following subfloors:

  • OSB board or wood Subfloors either plywood. Remember that wood subfloors must be structurally free and sound from movement.
  • Concrete subfloors. If you want to install hardwood flooring on concrete, you have to make sure that it must be at least 30 days old and must have passed all moisture tests.
  • Only if approved and recommended by the manufacturer, can hardwood flooring be installed over radiant heating systems.
  • Hardwood flooring can also be installed over tile, bamboo, stone and vinyl. These surfaces must be checked for integrity before performwood floor installation.

Unless approved by the manufacturer, hardwood floors are not recommended in areas where have the high moisture.

Wood floor installation

Find the hardwood floor installation Weymouth

2. HARDWOOD FLOORING INSTALLATION MATERIALS

Whether you need a hardwood flooring service or doing it yourself, hardwood floor installations require some basics materials such as:

  • Broom
  • Chalk line
  • Crow Bar
  • Electric Saw with carbide tipped blade
  • Hammer
  • Carpenter’s square
  • Jigsaw
  • Utility knife
  • Utility towels
  • Spacers
  • Tapping block
  • Soft rubber mallet

There have other materials needed depending on the type of hardwood installation.

Wood floor installation

It is necessary to hire a professional hardwood flooring service to install wood floors.

3. HARDWOOD FLOORING INSTALLATION TECHNIQUES

Hardwood flooring installation can be done when using the following techniques:

  • Glue down installation
  • Nail down / Staple installation
  • Glueless installation
  • Floating engineered installation

4. SURFACE PREPARATION IN WOOD FLOORING INSTALLATION

The surface preparation is the most important aspect of wood floor installation. Prior to installing hardwood floors be sure to:

  • Remove all existing flooring.
  • Using a moisture meter to test subfloor moisture. A maximum of 4 percent is allowed between subfloor and hardwood floor.
  • The calcium chloride test is recommended on the concrete subfloors.
  • The PH alkalinity test must be performed on all concrete subfloors.
  • The subfloor surface must be clean, level and free of bumps.
  • You should store the hardwood floor near or where it will be installed.
  • You must be measure the hardwood flooring moisture and do all steps in the following strict manufacturer’s recommendations.
  • It is necessary to remove all door casings in the area where the hardwood flooring is installed.
  • Remove molding and door.
  • Before the wood flooring installation, you have to sweep and pick up any debris from the floor.

5. HARDWOOD FLOORING INSTALLATION TIPS

When installing hardwood flooring, you should focus on the following tips:

  • A carbide tipped blade is the best to cut the hardwood flooring.
  • Use blue painters tape as a guide to reduce the chipping possibility.
  • To minimize chipping the wood floor, saw the pre-finished side first.
  • Roll out enough felt paper to trim the edges and cover the sub-floor.
  • Using a tapping block to move the hardwood into position.
  • Avoid cutting the wood flooring inside the room where the installation will present.
  • Start working from left to right.
  • Use floor cleaner which the manufacturers recommended to remove any marks that you have produced during the wood floor installation.

Access the website https://tonyfloors.com/ to have the hardwood floor installation Weymouth. It is necessary to hire a professional hardwood flooring service because installing hardwood floor yourself could be greatly difficult and mistakes costly.